Counting matching models…
Two pieces grip for the Ontos. This lets you add a little bit of color and makes for a better look. Prints as oriented in the file, with the same settings as the other Ontos parts. No supports required. Requires 2x M3x4x5 inserts and 2x…
Mag release with holes for the Ontos. Prints exactly like the original. This is only a visual improvement.
A replacement collet to use for you Ontos. It requires a 016 o-ring and an appropriately designed nut (such as the one linked below) in order to lock the barrel in place. I decided to remix the remix because it had too much wiggle for my…
A low profile Silly Collet Nut for the Ontos. I wanted a Silly Collet since I prefer tightening my barrel with O-Rings, but the kit I bought had a smaller barrel (300mm), so I needed to free up some space in order to attach my RIPPCAR.…
A remixed stock for the Ontos. It uses two M3x4x5 brass inserts at the back for the screws to prevent stripping into plastic if you ever wish to change the buttplate (which I will do later on when I finally end up buying TPU). Also added…
Created 6 new variations of the top slide for the Foxbat by merging together some of the existing ones: Top Picatinny + Side Bent Picatinny (Left, Right, Both) Top Picatinny + Side Picatinny (Left, Right, Both) They print exactly the same…
This is a remix of the middle piece of the Ontos Side Rails with widened holes to accomodate M3x4x5 inserts to try and make the connection sturdier (since I will be using it to attach a sling point) and to make it easier to assemble and…
This is a right grip panel with a pin guard for the semi-auto grip for the Ryobion. It has been created by combining the right panel from the Protean with the right panel from the Ryobion in my slicer and lining them up properly. This…
These are all currently available results.
