Counting matching models…
My Daughter wanted a holder for her earrings, so I designed a fancy scroll looking holder. Then I made some holes bigger for pins and cufflinks etc. I have added both in case you wanted one or the other. Print on side to avoid supports.…
A Enclosure for a PanelView + 6" HMI. I created this enclosure for mounting onto din rail to clean things up a bit when working out a project. The M5 screw holes are supported into the framing of the base to make it a little bit stronger.…
The roman blind cord joiner internals broke so I designed another one. Has been on blind for a couple of months, so I say it is ok. It is hard to tie the cords into the internal part and it took me a few goes but I managed to get them to…
Pool Fence Extenders and Spacer. I Came up with this design when shovelling dirt under my pool fence to meet the new regulations set out by my lovely Government. I thought there has to be an easier way. The regulations stated that the…
I found a floor lamp in hard rubbish that was damaged. I realised the damaged part was something I could design and print. The whole shade attachment was dependent on the base of the Edison fitting. Especially the clips that fix the top…
Dress Mannequin Tripod attachment. Infill 60% or greater and walls at 1.2mm minimum. needs Structure Print Settings Printer Brand: Creality Printer: Ender 3 Resolution: 0.2 Infill: 60% Filament: Pantech PLA White How I Designed This…
These are all currently available results.
