Counting matching models…
The Ecovacs Goat G1 needs transmitters/beacons to navigate around. Usually they include stands and a dirt screw to put them in the grass. However they need a lot of space around them to properly function, but my garden has quite a lot of…
This is a filter basket for a Juwel Bioflow filter setup. It has the dual height of the normal replacement filter basket. You can use it for cheaper refill filter pellets. Dimensions: 90mm x 90mm x 90mm A variant with and without holes in…
Case for a joystick connected to an ESP / NodeMCU with snapfit joints. There are little pillars to screw in the MCU and the joystick.
Trashbag holder for cupboard door with 22mm width. I use it to collect my 3d printing leftovers/failures in a trash bag. Print two of the holders and put them onto the cupboard door and hang a trash bag onto it. Using double sided tape to…
I print with 0.2mm since with 0.3mm the slicer might make to big of a variation it might not fit well anymore. They are designed to have a tight fit, so that they won't fall of. You might need a (wood) hammer to insert them. If using the…
Wall mounted holder for up to 14 tweezers or other flat tools like small spatulas.
A divider for small (transparent) drawers. They fit as a replacement for 34x63x2mm dividers, though for better strength they have ribs with 3mm thickness.
This is an adapter to put (two) f-tronic neutral/PE rails (e.g. SKPE34, SKN34) into a Hager distribution box (e.g. Volta). Print it twice, once for each side, one of them mirrored. Model is already in right orientation for printing,…
This part is a holder for the sun shade side awning (german: Seitenmarkise) by Songmics. The awning is delivered with a pole as holder, but I preferred it to be mounted to an existing girder, so I designed the attached parts. Those parts…
Tape roller for tapes up to 50mm width. The height (wall to roller) is ~80mm. I use it to hang tape below a shelf, but it could also be used to hang it from a wall. It should be easily printable without supports.
A very simple wall holder for sortiment boxes. I cannot really say what brand the boxes are, but they seem to be quite similar to some better known ones "Allit EuroPlus". Print Settings Printer: Lotmaxx SC-10 Shark Rafts: No Supports: Yes…
This is a round foot for a stackable aluminium garden armchair (german: Stapelbarer Aluminium Gartenstuhl) bought from ALDI. It is made for chairs with 25mm pipes as foots. Two variants are attached one smaller equal to the original and a…
For a lab / electronics workspace / makerspace a wallduct is very convenient. You can easily route your cables and place sockets where needed. I didn't want to have socket and usb/DC wall adapters everywhere so I designed this to provide…
These are all currently available results.
