Counting matching models…
Used to elevate the Black Magic Design ATEM Mini off the platform for better cooling. Print flat, not at the model is presented, no supports but use a resilient filament like Greengate3D PETg
These are the same model I sell commercially for the ATEM Extreme (ISO). 2 versions, one that is designed to be use as a left and a right, same file, and it is the standalone. The other has a right and left, that is the bolt down which…
Use the mold positive to make the silicone mold for 1.5"sqx6.5" rectangle, then use the mold holder as a reinforcement for the silicone mold. I use FS20 for the silicone and print the mold mother and holder out of PETg. Only need supports…
Stack the grits you need on one side, finest at the bottom, then as you use them move them to the other side. Print flat side down, any filament, infill about 15%, 3 perimeters is better than 2. If you don't want them this tall, just…
Hand sander for 2" disks, use TPU with varying # of perimeters and infill for more squish, or use any rigid filament for rock solid. Use appropriate 2" hook and loop for the backing
Hold a whole bunch of desiccant in your Polybox This is a multi piece model. Base, goes on the bottom add section with no top attachment points would be a mid section, then ass section would be the top. You don't have to add the no…
Uses standard skate bearings in the spool center holder and the axle in the Polybox to suspend the spool. This makes for much less drag on the spool and helps to eliminate TPU stretch before it gets to the extruder. To print, the filament…
Printed with PETg, .2, 3 perimeters for strength. Should print fine
Easy print to hold the Trent Bosch allen wrenches on any ferrous surface using 2x 5/8"x1/8" N52 magnets, although you could hook and loop it in place as well. The size on the outside is inset so you can identify it but not have to print…
Print out the grit numbers you store in your 2" Turningwood.com disk tower You can print them out of almost any filament, and you can use a .2mm layer height. Print them flat, I would recommend using supports to build plate for better…
Print out the grit numbers you store in your3" Turningwood.com disk tower You can print them out of almost any filament, and you can use a .2mm layer height. Print them flat, I would recommend using supports to build plate for better…
holds one bottle. would be too big if it was made for 3. Print in PLA/PETg/ASA, whatever works for you and glue them together. I recommend 3D Gloop. v3 has a tab on the bottom to act as a stop V4 has a hoop around the bottom, better for…
an easy tray for on top of the Robust American Beauty headstock. Designed for 5/8"x1/8" magnets but 15mm will work. Needs alot of supports as there are 4.5mm standoffs on the bottom
These are all currently available results.
