Counting matching models…
15 degree base for Tapo C200 camera or can be used whitout feet for a flat base. Supports needed on build plate only for the base. Tree supports are easier to remove. For asembly use 2 M3x10 bolts.
Print approx. €0.42–€0.52 excl. taxPreliminary estimate for PETGSource material: PET
A batch of small paracord beads. Resize it as needed in slicer program. ATM all have a 4mm center hole. Completely drawn with onShape. Post your makes if you like them. Bead1 similar to @AcEjbc bead but smaller and the center diameter is…
M10x1 (male) to M6x1 (female) adapter. It was a little tight so I had to run a M6 tap to clean the inside treads.
1.25" vaccum adapter for Dewalt table saw.
Mixed together the Stubby PG7 Cable Gland Mount by Tom Whitwell and Voron stealthburner umbilicus and chamber sensor mount by IconoclastXYZ .
Modded Gillette Venus Razor Holder by Bebbo to fit a 25mm shower tube. Also remixed one more sturdier with more space between the tube and the razor to better fit the angled type razors. Added pegs for better retention.
1/2" NTP Offset Nipple for electrical box. Has a ¾" offset.
A simple replacement lid for Nivea deodorants so that the container can be turned upside down and emptied completely. Made by [email protected]
A little clip to keep the memory from opening in the pocket, based on ruffle's USB storage clip. Best to print on it's side. Added stylized v.2 with lanyard hole and corrected orientation.
These are all currently available results.
