P
PrintablesRuben
gridfinity tape holder
holds all tape with a hole bigger than 20mm. 14u high so 91mm of stacking space
- Downloads
- 136
- Likes
- 26
- Rating
- 0
All models
Counting matching models…
P
PrintablesRuben
Magura MT - HS brake lever clamp
brake lever clamp replacement for your Magura MT or HS kit. Uses the original bolts, fits perfectly and is WAY cheaper if you have the 3D printer anyway. I printed this in ASA with 100% infill and acetone smoothed it afterwards. Carefull…
- Downloads
- 131
- Likes
- 13
- Rating
- 0
P
PrintablesRuben
Gridfinity divider box holder
just print 2 for every divider box you want to hold. Saves printing time, adds modularity and fits most boxes afaik. 33mm and 23mm versions available. Magnets are necessary to make sure it stays in place
- Downloads
- 51
- Likes
- 19
- Rating
- 0
P
PrintablesRuben
Lockring removal tool hollow
This tool is designed to remove 12-toothed spline lockrings on bicycles. Minimum wall count: 3. Recommended: 4 walls. recommend printing it with the tool side up, this way it will always be a good fit and more adhesion to your printbed.…
- Downloads
- 51
- Likes
- 4
- Rating
- 5
P
PrintablesRuben
Clip for maquette paper 6mm wall to 3mm floor
little clip i quickly designed for a maquette i did. This one is designed for clipping on a 6mm outer wall and holding a 3mm floor board with only 1mm spacing in between. I glued those on the floor boards just to be sure.
- Downloads
- 11
- Likes
- 3
- Rating
- 0
These are all currently available results.