Counting matching models…
Based on the RC2 Prusa design, I created a smaller version that would fit the Prusa Mini and still use the same shield hole pattern + new 3 hole punch version see V3. I kept it simple for ease of printing. The m3f has the headband and the…
Built custom sliding barn doors using purchased hardware. This came with little door guides that run in a slot on the bottom of the door. Once installed I realized the doors could have been closer to the floor and thus closer to the…
Clean up your build for Impulse RC Alien RR5. This includes: 1) Receiver tray, I designed it for FrSky X4R, but may work with others up to 22.4mm wide (could mount upside down for larger) 2) VTX tray, I designed this for TBS Unify Pro 5G8…
A much easier to use hand nut for the top lid of a Camco Propane Tank Added two versions that use a heatset thread insert (M5x9.5) - https://www.amazon.com/ruthex-Threaded-Insert-Pieces-Ultrasound/dp/B07YSVXWS8/ref=sr_1_1_sspa?th=1
Original artwork by TJ Kuhlman https://www.facebook.com/travis.kuhlman.359 I did some work on the SVG so that I could import it into Fusion and create the STL. It was created with three heights in mind so that each could level could be…
Camper Ladder End Caps Rough dimmensions 2 inch x 3/4 inch
The MN rebel alliance logos made into buttons. Two difference sizes (2 inch, 3 inch), uses 1 inch button/pin clasps ( https://a.co/d/05aeIfbC ) I used super glue to attach the clasps. They are designed with different heights for each…
When looking for a modular desk organizer I found something I liked over on makerworld https://makerworld.com/en/models/1397248-modular-desk-organiser?from=search#profileId-1448466 This made me want to make a matching stand for my Go XLR…
These are all currently available results.
