Counting matching models…
This is a remix from this wooly sheep from thingi: https://www.thingiverse.com/thing:95721 You have to support the ears since they are hanging on the tip. Due to the very small amount of filament on the first layer, print this layer VERY…
OpenSCAD - new Version - see below... I was seraching for a simple handing spool holder for mounting in my Ikea Ivar shelf system. Didn't find one - did my own! If you are familiar with openSCAD it's customizable in height and width of…
We have the problem that the small gliders inside the rail will chop where the rails are connected. This small gimmick will connect them better and let the glider "flow" better. OpenSCAD File included, if you wanna make them shorter or…
A easy support system for my Rode M5 matched pair Microphones to record in XY-Stereo Mode. Center hole is a microphone thread 3/8" to mount it directly on a microphone stand. The two other holes have on the top also a 3/8" thread to…
A smart Housing for the Homematic Smarthome Actuators - in this case for a 2x switch. The actuator is fixed by a smal gap where the tab goes in and opposite there is a small pin so it cannot move! The topcover is fixed with one M3 srew…
Ein Ersatz Sessel Gleiter mit Zentrierstift damit er nicht am Sessel verrutschen kann. Am Boden ist eine Vertiefung für die Aufnahme eines Filz Pads... A replacement armchair glider with centering pin so that it cannot slip on the…
These are all currently available results.
