P
Printableslmc555cmx/nopb
Rack and pinion gears
Rack and pinion gears
- Downloads
- 363
- Likes
- 22
- Rating
- 5
All models
Counting matching models…
P
Printableslmc555cmx/nopb
3D printed calipers 15cm
3D printed calipers, no support, 15cm
- Downloads
- 49
- Likes
- 5
- Rating
- 0
P
Printableslmc555cmx/nopb
Jumper wire holder
Jumper wire holder, print in PLA or PETG, works with m2 and m3 screws.
- Downloads
- 33
- Likes
- 2
- Rating
- 0
P
Printableslmc555cmx/nopb
Articulated, adjustable, 3D printed arm
An adjustable 3D printed arm using M3 bolts and nuts, you will need two of each per hinge. Use a reasonably hard filament like PLA. Adjust the friction of the hinges with a screwdriver, hinge needs support. I recommend printing with an…
- Downloads
- 19
- Likes
- 1
- Rating
- 5
P
Printableslmc555cmx/nopb
Jumper wire holder V2
Jumper wire holder (second version)
- Downloads
- 15
- Likes
- 0
- Rating
- 0
P
Printableslmc555cmx/nopb
Semi-transparent 2by1 grifinity bin with holes,
A 2by1 gridfinity bin with 3 dividers for smaller components e.g. THT resistors and holes which make it semitransparent and make it easier to print while still holding most screws, resistors, ICs e.c.t. without them falling out. It…
- Downloads
- 12
- Likes
- 3
- Rating
- 0
P
Printableslmc555cmx/nopb
Jumper wire holder
Jumper wire holder with M2 screws, make sure to not print this with elephant's foot or the jumper wires will not fit properly.
- Downloads
- 11
- Likes
- 1
- Rating
- 0
P
Printableslmc555cmx/nopb
1by1 semitransparent gridfinity bin with holes, one divider
1by1 gridfinity bin with holes so it is semitransparent and uses around 70% less filament while still storing the vast majority of things as the holes are too small to let most screws, all THT resistors e.c.t. fall through.
- Downloads
- 10
- Likes
- 1
- Rating
- 0
P
Printableslmc555cmx/nopb
1by1 gridfinity bin with 1 divider
1by1 gridfinity bin with 1 divider
- Downloads
- 10
- Likes
- 1
- Rating
- 0
P
Printableslmc555cmx/nopb
1by1 gridfinity stationary holder
1by1 gridfinity holder which holds pencils, pens, rulers and screwdrivers.
- Downloads
- 9
- Likes
- 1
- Rating
- 0
P
Printableslmc555cmx/nopb
print in place toggle switch
4g toggle switch, I recommend using PETG, ASA or ABS or another, higher impact resistance polymer. Prints in roughly 12 minutes. If using ASA or ABS, use a brim and increase fan speed for PETG due to a long bridge.
- Downloads
- 9
- Likes
- 0
- Rating
- 0
These are all currently available results.