All models

Counting matching models…

Anycubic I3 Mega Anti Vibration Feet

Print in PETG for optimal results, but PLA will work too. Print 4 of them and just put them under the original feet.

Downloads: 230
Likes: 20
Rating: 5

Yubikey 5 Series USB A/USB C Cover

Print standing up like shown in the CAD picture. Support only under the “Bridge” between top and bottom half. Print in TPU, i used Extrudr TPU medium so it doesnt need to be extremely flexible.

Downloads: 81
Likes: 12
Rating: 5

Order a print of this model

PrintablesRefnal01

KTM 990 Adv Brake Cylinder Cover

Cover for protection of the rear brake master cylinder. Print it with 100% density atleast in PETG, better ASA or PA

Downloads: 81
Likes: 12
Rating: 0

Order a print of this model

PrintablesRefnal01

Motorcycle licens plate holder (Quick Change)

You need a variety of M6 srews, washers and nuts to mount this on your bike. Lenght may vary depending on your Bike. The washer in the middle, which the magnet attaches to needs to be countersunk. I also recommend reinforcing your plate…

Downloads: 52
Likes: 0
Rating: 0

Order a print of this model

PrintablesRefnal01

KTM Lc4 Ventileinstellwerkzeug/ Valve adjustment tool

Das Modell MUSS auf dem dünnen Ende stehend gedruckt werden, da ein 1,0x5,5 Schlitz-Bit eingedruckt wird, ansonsten lässt sich dieser nicht einsetzen. Der Druck sollte dazu an der passenden Stelle (bevor das vorgesehene Loch überbrückt…

Downloads: 40
Likes: 7
Rating: 0

Order a print of this model

PrintablesRefnal01

Sodastream Grippy Bottlecap Sleeve

Grandma was having trouble to open the slippery Bottlecaps, so i made these sleeves that simply push onto the original Bottlecaps. No Glue needed. I printed in Extrudr Medium TPU but other TPU's should be fine too.

Downloads: 20
Likes: 2
Rating: 0

Order a print of this model

These are all currently available results.