Counting matching models…
I really liked Jacques Botha's Azul overlay , but I didn't want to glue clips to my overlay. I have a large format printer so I had plenty of room to make an overlay that fit over the entire board. The overlay is 242mm x 242mm so it…
I saw JokemanJim's fantastic organizer for King of Tokyo and I knew that this was the best storage solution I had seen yet for KoT. Unfortunately, his version did not support sleeved cards. I also only had 11 of the 13 monsters so this…
My first Gridfinity design. This holds one OLFA LA-X utility knife and a refill cartridge. I started with scheff's Solid Bins .
I took inspiration from this Pop-Out Hex Garden and skinned it with a Super Mario Brothers theme inspired by this pencil holder . There are drainage holes in each pot that drain to a common reservoir in the rear. Everything prints without…
I needed a spacer to allow the pullout spice rack to fit over the lip of my cabinets. I probably could have designed it to use a whole lot less filament.
This holds my magnetic paper clip holder. You can also store paper clips in it without the holder. I made this without magnet holes on the bottom.
This holds my Intellicharger i2 charger along with it's power cord. I don't use magnets so there are no magnet holes in this model.
These are all currently available results.
