Counting matching models…
Recently completed a set of Mandalorian armor for Halloween. A number of the models I found needed some modifications in order to work with my outfit. I will link to original models for all the parts I made, and am only uploading the…
I have started flying the F/A-18 in DCS World and was giving thought to building out an upfront controller panel when I remembered I had a Streamdeck sitting around from a previous project. This is a simple case to mount a Streamdeck XL…
This is a simple remix - merged the wire shelf holder for the HMD with the stand-alone wall mount from the other source item. Fully compatible with the HMD mount from the wire shelf unit - I made no changes to that so didn't upload it…
Shortly after finishing my previous thing to add a button box to the Saitek X52, I took the plunge on a Thrustmaster Warthog throttle. This is a minor adaptation of that design to add a single, smaller button box on the left side of the…
In my simpit, I use a basic dual-monitor arm with VESA brackets to mount my Cougar MFDs. This is a remix of this original mount which is intended for use with a small screen behind the MFD. Since I play in VR, I wouldn't be able to see…
Much like the designer of the original Thing I was looking for extra buttons for VR flight sims. Since i play in an Obutto R3volution simpit , there is only a small throttle support plate rather than a desk for the throttle, so it was…
A simple mount for this USB numeric keypad which I used as a cheap up-front controller for flight sims before upgrading to a Streamdeck XL . The keypad just press-fits into the frame. The mounting hardware will fit any 75mm VESA hole…
See hivemonkey.com for the full project writeup, including electronics, code, Stryfe modifications, etc. This is a case specifically designed to fit on the left side of a Nerf Stryfe and mount a particular homebrew electronics package,…
This is a remix, but I have lost the original link. Please advise if identified, and I will update the model immediately. This is a mount for the Entaniya waterproof pi-camera case designed to mount on a coral frag holder, for use inside…
These are all currently available results.
