Counting matching models…
Ribs have been slightly oversized for clearances. Note, the body of this model is round pipes, with a midsection through the Z origin. Your cut operation only needs to be Z+. Does not contain the center badge. Test printed and fit on…
After tinkering around for a bit, and finding only inserts that were AI generated or did not fit quite right, I downloaded the cardholder model remix from markopolo311 (thingverse) and gutted the middle out. I then keystoned a sold block…
Includes two halfs, alignment pins, rod split for easy printing, and a handle. Held together with superglue.
Printed grill down, with minimal supports. Printed spacer with case side down with minimal supports.
3inches x 5 inches silica gel holder with screw lid
This is an insert for an Apache 1800 Case that holds a 1001U amp and low voltage cutout. There is a path for running the speaker wires and the low voltage cutout case is removable for easy wiring. I attached a project from my slicer to…
Print List: 2 Arms, 2 Pins, 2 bearings and 1 Roller. Bearings are 608 bearings, printed with .177 cal BBs. To print these, you have to pause the print to install the BBs, I found layer 24 works best with a .2mm layer height, but you may…
This is non locking, reversable Fridge/Freezer latch to keep the doors from opening. Use double stick adhesive pads for installation. Buttons are designed to snap together, pressing on a hard flat surface. Printed in PETG, Latch is 15%…
Printed in PETG, 25% infill, no supports. Inner die shouldbe printed in the vertical position as shown in the model. This is light duty for removing stickers, cleaning stovetops, and as a print bed scraper. If you over tighten the screw…
Bulkhead‑Style Drain Fitting This is a compact bulkhead‑style drain fitting designed for clean, reliable pass‑through drainage in enclosures, tanks, coolers, or custom 3D‑printed projects. The fitting installs through a 1.5‑inch hole,…
Typical bearing, uses .177 BBs. Stop print around layer 23-24 to insert BBs. Ensure zhop is high enough so the extruder does not knock the BBs out. Slow print speed down as well helps to keep them in place.
The mount and tach are secured with zip ties, and the motor used is a 30hp tiller model. A link is provided for the tach that was incorporated into the design.…
cuPhone holder, sized for standard Iphone, holds a slim can with koozie, or fat can without a koozie. Stick down with 3m double sided tape.
These are all currently available results.
