Counting matching models…
0.15 layer height with ironing on every top surface. My print came out as a very close fit for the blade and the upper and lower parts of the container. You may want to play around with the scale of the parts to refine the fit according…
The port is positioned as far to the side as possible to maintain good air flow for the mcu fan. I am not sure if it will work if the z stepper plug is on the same side as the power switch corner, as the 30cm ethernet cable is a tight fit.
Attach to the battery cover with double-sided tape. 10mm extension.
Apple AirTag holder for aluminium card wallet like this: https://bit.ly/3aUfsMb For secured wallet, I made mine from a cheap copy but will probably work. It is a tight fit so you'll have to use a rubber mallet to install it.
My own interpretation of the original part supplied by dealers. It will fit any Lancia Delta integrale with an original radio/heater control frame. Given the car's age, each frame will be worn out differently, so you may need to add some…
For best results: PETG/ABS/ASA, 0.2 layer height, 9999 wall count! Nut pressed in after printing.
Made from leftover miscellaneous 3D printer parts. A finished spinner has one gear which I refer to as a wheel, driven by a finger. Small and large sizes. You can just make one half of a wheel if you don't want a reversible one. You can…
These are all currently available results.
