All models

Tekno SCT air guards

I printed mine with TPU with four wall sides top and bottom at 80% gyroid infill. Stiffens up the entire nerf bar and will last forever.

Tekno EB48 NB48 rear mud guard

Print in TPU, will last forever. Remove if the track loamy/wet as the produce drag

Tekno ET48 NT48 Mud guards

Print in TPU, will last forever. Remove if the track loamy/wet as the produce drag

MIP Driver Magnum T Handle set

Print these however you like. I did ABS with four walls top and bottom 40% infill. There is a set of four handles with numerical labels and a set of two handles with a L and S label

Tekno SCT410 2.0 Rear Mud Flaps Clean Version

THIS IS A CLEAN VERSION WITH NO WRITTING ON FLAPS. Printed in TPU 95 with 4 walls top and bottom 80% gyroid infill support on build plate only

Tekno SCT410 2.0 Hobby Wing Switch mount

Printed in ABS at 4 walls top and bottom, 40% cubic infill. Fits TIGHT on side guard, will need to short 2.4mm screws for install. Then use double back tape to secure your switch in place. WAY easier for a marshal to locate mid heat!

Tekno SCT410 2.0 Rear Mud Flaps Dirty Version