Counting matching models…
I made this because I wanted to mount a 40x20mm fan on my machine but there didn't seem to be a mount that didn't use too much filament Print settings Filament: Overture PETG Supports: Yes, Support from build plate only Infill: 40% Slicer…
I didnt have any crimpers for jst connectors so instead I made this so i could plug in a superPinda into my SKR pico without spending money on a crimper kit. How to use: first extract the 3 pins from the (50-57-9404) molex connector on…
Mounts your daygreen dc-dc 5V 50W (B10-1224-05) buck converter onto an aluminum extrusion, ideal for mounting it inside the underside of a switchwire. Fasteners Required M3x4 SHCS or BHCS M5x8 BHCS M5 T-Nuts Print settings Layer Height:…
I modified the EZABL mount in the original post to accommodate a small inductive probe like the SuperPINDA, I have not yet tested it but it should work if the original EZABL mount works with yours. Probe offset is as following X: -35mm Y:…
Let's you put your university bus pass sticker (approximately 26mm high and 45mm wide) on a tiny tag that you can put in your keychain instead of your wallet for easy tap. Requires some careful peeling. V1: Initial Version V2: Added two…
Work in progress Printed in ABS (in picture), avoid printing in PETG as it may be too flexible and sag Requires M5 BHSC screws (8mm long + 16mm long) and M5 sized rack screws (Haven't tested M6) for mounting onto a rack, and M5 heatset…
Makes the tensioner work with the thomasfjen v1 ender 3 to switchwire conversion.
A mount that slots in where the rear-view mirror would be, can be used to put a dash cam or gps if adapted.
These are all currently available results.
