Counting matching models…
Floss picks case for EDC bag or pocket. Could be used at home too if you store them in a drawer. Lid has notches and base of case has flexing catches so the case stays closed in a bag. Print settings: .2 snug supports
I removed the USB-C cable area from @ PjotrStrog 's model and replaced it with space for a SS-02 solder sucker. Initially added a second set of clips but the case would not close with the solder sucker in it as it would hit the spare…
This is a 3x1 gridfinity holder for INDX nozzles. I included a label and raised it slightly in case you want to colour it with sharpie instead of print with the colour. I placed the thumb cutouts where it seemed to make the most sense.…
Table riser for use with Inland Coolant Pump for Kristall 2000S Glass Grinder. I added a spiral internally and that has helped with consistency in getting the water started flowing up and out of the spout. Takes a bit to start sometimes…
Table riser with modular ends to best fit your grinding bit and have control of your glass. I have tested all 3 and they work well. Printed with 4 walls. I do not know if this rigidity is needed, but I wanted the clips to be solid.…
Holder for the Fanttik F2 Master set that mounts to multiboard small holes using 9mm T-bolt . I have included the link because even knowing what I am looking for it can be a pain to find on their site. Set at a 10 degree angle for easier…
Extended Brompton Seat Height insert that is an additional 50mm taller. Print instructrions: Printed at a 50 degree angle to get the tab section to be a bit stronger. It was quite fragile when printed completely vertical. If you "Open as…
These are all currently available results.
