All models

Counting matching models…

All collet holders, ER8, ER11, ER16, ER20, ER25, ER32, ER40

Dimensions: 150 x 130 x 29mm and 150 x 64 x 29mm for the halved version Fixed issue where stl models were 10x smaller

Downloads: 91
Likes: 5
Rating: 0

snail drawer pull, snail knocker, doorknob, doorpull

Use double sided tape. I recommend to print it with +20% infill, otherwise it will sound hollow and cheap Print in 3 parts and just slot it together, usable just as is, but glue is recommended.

Downloads: 90
Likes: 29
Rating: 5

Order a print of this model

PrintablesJDesign

Small Box or case for earplugs

Dimensions: 54 x 30 x 16 mm It snaps into each other Max layer height 0.2 Close it with handles near each other :^)

Downloads: 51
Likes: 4
Rating: 5

Order a print of this model

PrintablesJDesign

Customizable SKADIS type board with hooks and magnet slots for whiteboard

Dimensions: 146 x 46 x 4mm print with logo facing up(it will be facing the wall) print max 16hooks at a time print board and hooks separately use 5mm brim for Board due to its large surface area to avoid warping

Downloads: 37
Likes: 14
Rating: 0

Order a print of this model

PrintablesJDesign

Centauri Carbon, CC, Internal poopbin transparent

I have used the version remixed by clogged_nozzl3 I highly recommend it, no need for heat inserts.

Downloads: 5
Likes: 2
Rating: 0

Order a print of this model

PrintablesJDesign

Universal Dispenser, Dicetower

Dimensions: 170 x 120 x 106mm Print with support for bridge Use 5mm brim to avoid warping

Downloads: 3
Likes: 4
Rating: 0

Order a print of this model

PrintablesJDesign

Angle Bracket Corner Joint (M8 & M6 Variants) profile4040

Available Model Variants M8 with Slots: Allows fine adjustment and sliding alignment along the profile groove before final tightening. M8 (Standard Hole): Maximum mechanical strength and precise alignment with zero slip under high loads.…

Downloads: 3
Likes: 2
Rating: 0

Order a print of this model

PrintablesJDesign

Soap holder, barsoap holder for bathroom

Important note: When sticking the holder to a tile, tilt it accordingly so the bottom is tilted.

Downloads: 1
Likes: 1
Rating: 0

Order a print of this model

These are all currently available results.