Counting matching models…
Similar to Milwaukee 49-90-2037. Sized for the Fuel 2.5 gallon Packout Vac, but I imagine this would fit other Milwaukee vacs. Print standing up, no support. Use a ½" (OD) vinyl hose, will be tight to install but will fit.
Remixed for 10 capacity and length reduced by 3 mm so it would fit on my circular bed. Print Settings Rafts: No Supports: No Resolution: 200 Infill: 20 Filament: PolyMaker PLA Category: Tool Holders & Boxes
I recommend printing in the orientation shown with support.
This model was made to connect my Rocker Dust Right kit to my Dewalt DWE7485 , although I assume this works for most/all Dewalt table saws. I suggest printing in the orientation shown in the 2nd picture, with support only for the ribbed…
This is pretty custom for my needs, but thought maybe someone else might like it. This was designed to hold: Megapro Ratcheting Screwdriver (hole was drilled in cart for shaft to drop through)…
Dock to hold and XDm with a PL-MINI 2 light and charge it. Print the chamfered version and add supports, or print the square version without supports. Chamfer was added for drawer clearance and is what is shown in my images. Category:…
I printed in PLA with 90% Tri-Hexagon infill, 3 walls. It feels strong enough, but I would not weaker than this.
I wanted a riser for my dryer to match the below linked isolators I was using on my washing machine. I added a counter sunk hole in the center if you want to anchor these to the floor. This can help so you can get the dryer on the back…
Magnet carrier for the Sofirn LT1S. Use 12 of the below linked magnets. https://www.kjmagnetics.com/proddetail.asp?prod=D7H1 Category: Electronics
Bracket can used with or without a spacer. Spacers are so the cam can be mounted at a greater downward (or upward if assembly is installed inverted relative to my picture) angle. I would jump right to the 10 degree spacer and not use the…
Clip attaches to 9mm cord with a zip-tie.
Hammer made for OSAT project at Michigan Tech Use a 3/4" x 3.5" bolt Print Settings Rafts: Doesn't Matter Supports: Doesn't Matter Notes: Category: Hand Tools
Custom control box fit to my RF-30 clone.
Designed to magnetize to a 96 mm base. Magnets Used: https://www.amazon.com/gp/product/B0CWNMZV1Y/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 Light Used:…
These are all currently available results.
