Counting matching models…
My Flashforge AD5X setup called for a front facing IFS mount to be inline with my dryer box. Nothing was quite matching what I needed, so I designed one in tinkercad. Once installed, it was clear that the IFS cable needed to shift to…
I needed something to hold all the grad party invites rolling in. Putting each one on the fridge was taking up too much space, so I created a simple holder to keep them all in one place. This uses 6mm x 3mm magnets as those were the only…
My brother was needing some minimalist men's and women's restroom signs for a project. He sent me a sketch of what he was looking for and I started tinkering. Here is the end result. They are approximately 1ft/30cm tall. It is designed to…
I hit a snag while printing from my dryer box recently. A roll was getting close to the end and was too light to remain upright/stable in the dryer box. It was pulled off center and caused a mess – see last photo. After googling, it was…
My daughters keep adding to our coffee station a home. I felt it necessary to create a matching Torani flavor bottle holder to the mix. I created this stand/drip tray for the Torani 750 ml sized bottle to match a print I did for their…
These are all currently available results.
