Counting matching models…
Mount your spools to a Skadis board instead of the side of your printer. A disadvantage of mounting the spoolholders on the side is that you have to remove all four of them to remove the side panel. And installing them is difficult. You…
These dumbbells increase how much water you have to push around when exercising in the pool making your workout more intense, either on your own or in a water aerobics class (aka aqua aerobics or hydro aerobics). If you have large hands,…
Add this badge to your Core ONE to commemorate all the hard work you did putting yourCore ONE together. You choice of English I BUILT IT or Czech POSTAVIL JSEM or both. I recommend printing in black, gray, and orange. Use either black or…
A great design by @Mape but it wouldn't fit the heavy duty spring 10mm x 20mm x 1.2mm x 7 coil spring that I have. I shortened the piston from 16mm to 12mm so it would fit. This spring is very strong. If you want to the spring to be a…
The only simple machine tool you’ll ever need, from the ingenious mind of Randall Munroe. ¹ My local hardware store was out of stock of the tool, so I created my own. I made small adjustments to make it more practical to print, but this…
These simple devices bling up your shoes while helping to keep your shoelaces tight. Printed in TPU/FLEX, they will stretch a little if you pull tightly as you tie your shoes. Then, while you're wearing them, they'll pull back on the…
I put up new shop lights in my garage and they hang by two screws. It's almost impossible to install them without the light wobbling a bit every time you pull the chain. And worse than that, there's nothing locking the light onto the…
Add this badge to your Core ONE to commemorate replacing the main cable, in your choice of MAIN CABLE or HLAVNÍ KABEL. The hard part of adding this skin to your Core ONE is the work on the inside. Background: I had to replace the main…
Print with layer height 0.2mm and concentric top and bottom fill pattern. This scraper is particularly useful for vase mode prints where the bottom of your print is large and flexible and adhering to the bed (and since the print is only…
Mount the filament sensor on the back of your Core One by inserting this adapter between the stock sensor mount and the back panel and using available holes on the rear profile. Simpler than reprinting a new mount but does require…
These are all currently available results.
