Counting matching models…
A redesign of Zach Freedman's jumper wire comb so it doesn't require magnets. Should be fully compatible. The included picture shows both my comb and Zach's original in one of my bases. Changes: The base is one piece, rather than two. The…
My attempts at printing whole 5.56 snap caps failed, because the rim would get ripped off. This version just fills the casing to make it feed correctly. It runs the length of the cartridge to help get a consistent length. If you don't…
I started trying to use the “Walther PDP Compact Magwell-Compatible Baseplates” , but was unhappy with the retention. It felt like the base plate could come off accidentally. I haven't retained any dimensions or design features from that…
The all black AFG in the cover photo is this model, compared with the model linked below partially painted in the back. It was almost what I wanted, but I had a few tweaks I wanted to make.…
The 3mf model is in the orientation expected for use. It will need to be laid flat for printing. The corners will need to be knocked off the top hook to fit properly. This makes the laser cut version fit much more nicely. I switched to 3d…
I fought with my bed binding for a long time before I figured out it was because the T-nut mounting screws had slid into the spring in the backlash nut. Downsides christophmuellerorg's original design is excellent. The extra space on the…
Source: https://cad.onshape.com/documents/8e32626565cbbeef5e4cd8d3/w/b09365e8f3eeb6319f5a1b46/e/11d4dc9550a5c0cac525a516?renderMode=0&uiState=64aaf63abe953312f726ec55
An M3 x 4mm L x 5mm heat set insert, and a M3x8mm screw is required. This locks the magazine in place. Otherwise it tends to slip off when you slam it home. The outside profile of the rail on the bottom is technically Picatinny, but I…
Designed to allow mounting of a Mantis X training system to the base plate of a Sig Sauer P365 X-Macro
Disclaimer LiPos are dangerous . I'm an amateur. Use this design at your own risk. Build Description The boost buck converter input is connected to the battery, and tuned to provide 24V to the fans. The resistors are connected in series .…
A MeshCore tree node constructed using some of the most commonly used parts. The main body is designed to be printed with the smallest part touching the build plate. Full Source:…
These are all currently available results.
