Counting matching models…
This is a rear main seal driver for all GM Ecotec 2.0/2.2/2.4 4 cylinder engines. Simple design nothing fancy. Use a small 2x4 to hammer on to avoid damaging the tool. Note there is no depth stop, so make sure the seal is driven as far as…
The console has four feet, so print four times. Attach with double sided tape such as 3M 300LSE, or your choice of glue. I used Polymaker 90A TPU. Any TPU should work though. 230C nozzle, 60c bed. .2 layers, 25mm/s. Printed on my Sovol…
This is my axle seal driver for late model GM FWD manual transmissions. Specifically the Cobalt SS, Ion Redline, HHR SS, and any other transmission in the F23, F35, and F40 line. Including Saab 9-3 and 9-5 F35 and F40.
So the feet on my Genesis 2 were lost to time. So I decided to whip up a quick model to replace them. I printed in 95a TPU, you can use any TPU you want. 100% infill worked, and 15% also worked. Depends on how stiff you want them. .2…
Print these in TPU or other soft filament .2 layers, 100% infill. I used Polymaker 90a TPU for testing. Its not as soft as the original rubber, but should last longer. I made them a little taller than the originals so they contact before…
This is a remix of the Laser Bear Industries Dreamcast MODE Mount . This version removes the top SD card loader for use with Internal HDD/SSD only. It also adds 2 more 1.5mm fiber optic light pipe holes so you can see all 3 status LED's…
Print in .2 layers 10-15% lines infill. Any filament works but PLA is cheapest. This is my final revision. This version you will slide the Q10 display under the protruding tabs. These tabs hold down the display, and ensure even LOCA…
The LCD has two feet, so print twice. Attach with double sided tape such as 3M 300LSE, or your choice of glue. I used Polymaker 90A TPU. Any TPU should work though. 230C nozzle, 60c bed. .2 layers, 25mm/s. Printed on my Sovol V06 Plus.
This is a remix of laserbear's Dreamcast MODE mount midframe with more clearance for 2.5" ssd's.
Print in .2 layers 10-15% lines infill. Any filament works but PLA is cheapest. This is my final revision. Pictured is MGBC jig, DMGC is the same method. This version you will slide the Q10 display under the protruding tabs. These tabs…
Print in .2 layers 10-15% lines infill. Any filament works but PLA is cheapest. This is my final revision. Pictured is MGBC jig, MGLC is the same method. This version you will slide the Q10 display under the protruding tabs. These tabs…
These are all currently available results.
