6 models
It's a tray of 154 rds of 9mm. Stacks 5 high, in two columns in your standard ammo can. I've heard them referred to as .50 caliber cans, but mine's marked for M855. It's 5.5"x11" approximately anyway. Watch out for "elephant's foot"…
I think Roombas make too much noise when clanking over the grout lines on the kitchen tile. Printing this with ~25% infill in TPU makes the problem go away. I've only tested with the j7+, but I bet iRobot reused the same wheel in other…
This is an earlier model of mine, a bit primitive. I used cheapo binding posts from amazon (eww) and a military-style flip-up switch for main power. Don't forget LED resistors. It's meant to glue/tape/whatever to the top of the PSU…
Tired of wobbly cafe tables? Bobbling bistro sets? Then ACT NOW and print this in TPU with a 25% 3D honeycomb infill! Feel the rock solid confidence of drinks which don't slosh, plates which don't fall, and breathe easily again. Clear…
This is a part which drives the mirror-positioning worm gears in the side mirrors of a 2017 Hyndai Elantra GT. It's a single thread helix, supported by flexible fingers attached to a ring with outer lugs which lock engage the rest of the…
Thumb wrench with a 7.2mm hex for changing standard Prusa nozzles. I've had a working one in PC for a long time, but I'd bet PA-GF/CF, or other composite would work better.
These are all currently available results.
