Counting matching models…
My first 3D model is of the Framework laptop and I thought I’d share it here in case it helped anyone. The dimensions should be accurate to +/- 0.5mm, better in smaller areas where I was able to measure with micrometers, say +/- 0.1 mm. I…
This is a simple box for seed packets. It has a tight-fitting lid, making it almost airtight. There are 3 chambers to separate seeds. The sides are angled and the front is low to allow you to read the labels. The lid has a matching angle,…
This is a minimalist stand for the Star Trek original series flip-up communicator. It holds up the communicator at a 45 degree angle for display and the holders stay out of the way as much as possible. It allows the communicator to stay…
This is a downspout guard that fits over a squarish 3" X 3-¼" downspout with multiple rows of drainage holes. The drainage holes on the bottom are flush with the base, which should prevent any water retention. A screw hole is provided for…
This is a mount for attaching Malolo's screw-less / snap fit Raspberry Pi 4 Model B Case (default height) to an Ender 3/V2/Neo/V2 Neo 4040 extrusion, or any other 4040 extrusion with dual 6mm channels. Printed at 0.20mm layer height (or…
The ubiquitous red bodied Redrex aluminum extruder (single or dual gear) has a filament entrance hole that is much higher than the original or all-metal Creality extruder. This is not an issue until you also want to install Creality's…
This is a bracket to mount a 12" Luminiz T512124-F1WWC LED undercabinet light to a Creality Ender 3 V2 Neo. This should also fit the 2020 extrusions on the Creality Ender 3 S1, S1 Plus, CR-M4, CR-6 SE, CR-10 and CR-6 MAX. On these…
This is a mount for attaching Rocky's Updated Pi-4 Case with PoE+ Hat to an Ender 3/V2/Neo/V2 Neo 4040 extrusion, or any other 4040 extrusion with dual 6mm channels. Printed at 0.20mm layer height (or 0.28mm, it doesn't need to be pretty)…
These are all currently available results.
