Counting matching models…
Remixed MakerBot's fidget gears to add an integrated keyring. Maybe my son won't lose them now! Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.2 Infill: 50 Category: Keychains
Customized version of https://www.thingiverse.com/thing:62800 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=62800 Instructions Using the following options: gopro_primary_kind = triple…
Couldn't find a good mount for my helmet/light combo. So instead of using a bunch of zip ties or twist ties, I modeled one in Fusion 360. It's a flat style GoPro mount that sticks on with double sided tape where the vizor meets the…
A simple minimalistic clip to mount a bowden tube to the top of a Prusa i3. Clips on just like the original spool holder and has an M6 threaded hole for the bowden fitting.
The gas cap tether on my Jeep JK has broke twice now. Time to make an improved TPU one! It can be printed in three parts for easier printing and less stringing. They are a tight fit, you may need to warm it up a bit before pushing in the…
Replacement cap tether for a narrow mouth Nalgene water bottle. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.28 Infill: 100% Filament: Generic TPU Notes: It helps to warm it up a bit to…
Just a quick remix of eoyilmaz's Ender3 pi enclosure with an undermounted 30mm fan I had for the pi. Bringing the cool air in from the gap underneath will helps to keep the whole enclosure a little cooler! Added version for using a…
Simple magnet fidget with strong 12x3mm neodymium magnets. There are 8 magnets in each side, 16 total. They are quite strong so be careful, they can break if you let them snap together too hard! If printed with 0.2 layer height, the pause…
Our lawn spreader decided to explode last fall. After looking it over, the gears and shafts were all fine, it just dried out an bound up. The outer gearbox case was destroyed though, so I modelled a new one! Unlike the original the…
Our Neato VX Signature Pro vacuum occasionally hits a floor transition (or kid toy) hard enough that the dirt bin pops out. It would then sit and do nothing until someone pushed the bin back in. 3D printing to the rescue!! This little…
Rear dual antenna mount for receiver (RP1) and VTX antennas with a swappable VTX antenna SMA connector. Printed in TPU with a brim for adhesion. It has survived quite a few falls, so I thought I would share.
Redesigned magnet for the universal Klein meter clip.
Simple Logitech C270 webcam mount for a server rack. Attaches with a M3x25 machine screw.
These are all currently available results.
