Counting matching models…
I had some 608ZZ bearings in my workshop so I start to design a filament roller by my self. This is the result. To make it a bit smaller the roll could be 1-2 cm shorter. I took me a bitt of effort to design all parts to make them running…
Holder for up to two scalpels and 6 blade replacement kits
Simple design to build a box of 4mm plywood. I added to Fussion 360 file so you can adapt it to your needs. My plywood was 3.7mm so I designed the slot with 3.6mm to get a tight fit. I glued all together with super glue so the box was…
To improve my freeCAD skills I designed this Basic spool weight can. It is designed for Bambu Lab spools with an inner diameter of 55 cm (the can is 54cm). Actually I put 8 AA batteries inside but I ordered some weights on Amzone.…
I mad an adapter for my Bosch GEX 125-1 AE executer grinder. There is a rubber seal at the end and I designed a notch in the adapter. It's hard to push it over but afterwards it stays secure in place.
On the backside is space for 5mm round 3mm thick magnets. It's a tight fit so it shouldn't be necessary to glue them in.
A simple knob to add to an hex nut or to an screw with a hex head. The width and the hight of the knob and also of the hex nut can be adjusted via Fusion360 parameters. The stl works for me for an M6 with a tight fit. Maybe you have to…
I designed a holder for my Raspberry Pi 3 to attach it to an Ikea cabin. I put som M5 bolts in the pre drilled holes to attach the holder. 4 M3 Hex nuts has to be added. In my case they have a tight fit but you can also clue them in.
These are all currently available results.
