P
PrintablesEsmarra
Key holder with embeded keychain
The original author removed the keychain holder, so I made a Parametric Keychain generator, for the model.
- Downloads
- 248
- Likes
- 51
- Rating
- 5
All models
Counting matching models…
P
PrintablesEsmarra
S300 Mini-ITX Case Mod: Vertical Stand
I wanted a way to have my S300 case in a vertical position, but did not want the cables hanging from the top, so I've designed this model to do just that. You might need a PSU cable with 90deg. If the 90deg is facing the wrong way simply…
- Downloads
- 108
- Likes
- 10
- Rating
- 0
P
PrintablesEsmarra
Cable holder with self locking mechanism
Self locking wire holder. Parametric design.
- Downloads
- 47
- Likes
- 12
- Rating
- 0
P
PrintablesEsmarra
![34T ABEC Pulley [Two Part]](https://media.printables.com/media/prints/525076/images/4245639_7d70ea1d-66f0-4696-b136-4876d0fa01da/screenshot_7.png)
34T ABEC Pulley [Two Part]
Interchangeable Pulley Desing. Objective swap between ABEC / Keggle Mounts or Custom teeth numbers without much hassle. Also splitting the model into two parts makes printing easy. The model is designed around the screws inserts for ABEC…
- Downloads
- 43
- Likes
- 6
- Rating
- 0
P
PrintablesEsmarra
Minimal Dual Board holder for IBT-4 H Bridge Motor Driver
This is a simple PCB riser for two IBT-4 H Bridge Motor Drivers. It uses the very little plastic, and its a very fast print. Intended to use M3 screws to hold it in place.
- Downloads
- 43
- Likes
- 0
- Rating
- 0
P
PrintablesEsmarra
Heltec v3 LoRa32 with battery
Created this because I wanted my mesh node to hold power if I need to move it. Started with the base from @Shred's to make my mods. I'm unsure of the current power draw, but should last at least 4h (no wifi) Required Hardware: x1 380mAh…
- Downloads
- 32
- Likes
- 3
- Rating
- 0
P
PrintablesEsmarra
Aomway Commander Tactile Button/Switch Replacement
Micro push button switch replacement for the AOMWAY Commander FPV Googles. This print is quite delicate and the tolerances of the inner square hole are wrong. You might need to heat up the under side and widen the hole with some tweezers.…
- Downloads
- 6
- Likes
- 0
- Rating
- 0
These are all currently available results.