Counting matching models…
I Printed these at 200% as the original design was a bit on the small side, they work really well and stack for easy storage. No special instructions for how to print your normal settings should work.
Made this vase for holding Lego Flowers. The silver one is the smaller version of the vase and allows for the flowers to spread out more. The black version is about an inch taller than the silver and keep the flowers a bit closer…
Simple castle that I designed to be used with little people. while a large print should fit within most standard build volumes. I used supports for the arch way and that was it. Infill was 5% just so that the tops would turnout well.…
A Guide to cut 1 in or smaller diameter pipes with a Hack saw. Has a 30, 45, and a 90 degree angle. Don't think scaling will work very well since the gaps will become bigger and not hug the blade as tightly. Also I would rotate it 90…
This will take a hand plane with a 25 degree cutting angle and give it a 45 degree cutting angle. I used some 4 mm screws to hold the locking block in place. Works well if you have a sharp chisels, otherwise does not work very well. If…
I halved the original model because I have modified my 3d printer with a VORON hot end and that removed some volume in the Y direction. The print is designed to be printed twice and then slid together using the dovetails for alignment.
A pretty simple print, I printed this on an Ender 5 using 0.12 layer height and it turned out great. You should not use supports and infill is optional but does help to make it feel more substantial.
These are all currently available results.
