4 models
A small, simple device for protecting the corners of a print from drafts that can lead to warping or corners raising off of the print bed. Not all warping is due to drafts, but if your printer is in a high traffic area or by a window this…
This is a variation on http://www.thingiverse.com/thing:8023 which can hold the PTFE tube (or tubes!) from http://www.thingiverse.com/thing:9604 . On my ToM, the PTFE tubing sagged down after leaving the stacked guide to such an extent…
It's a foot...for a dishrack. With this device, you can tilt of the rack so that it fits over the lip of a kitchen sink and actually drains! Instructions Printed on an Ultimaker, though any printer should be able to print this with no…
This is a 3D printable infographic showing a somewhat random selection of launch vehicles used to get to low Earth orbit. The infographic has three pieces of information: (1) total cost to the customer of one flight, in US dollars FOR…
These are all currently available results.
