Counting matching models…
This is a drawer that goes into my pc into one of the slots where a cd player would normally go. I don't know why my case has 3 slots, but 2 of them were empty so I designed this. To get a part, you need to print v4 and v5. They're just…
EDIT: removed photos of my keys lmao past me was so bad at security Duct tape has a myriad of uses and is usually the easy go-to solution for when things break. Sadly, there is almost never a roll of duct tape within reach when things…
This is an effector that has the mount for the hotend raised so that you can get that extra 5 cm of build height. My sintron kossel mini has some Chinese e3d clone, so I measured it and arbitrarily picked a height for the design, but it's…
This is a simple holder for contacts for electrolysis. You cut the side out of a soda can, sand off the paint, then put the can sides into the holder. then attach the top to the top of a bottle/container and put wires through connecting…
Note: This is a work in progress!! There are still a few tweaks I need to make before it's actually a good design. ex: more stiffness, embedded nuts, ability to tune center, etc. (lwk im not sure if I will do that because it's usable rn…
This content is all out of date. Check the github repo for the most up to date info and files. Overall recommend 0.15mm layer height max; there are small details that need to be resolved well try to print on the hotter side with less…
These are all currently available results.
