Counting matching models…
Thin-wall printing is necessary for the frog in order to print a single layer. A gap may remain on the top of the frog depending on the quality settings, but I left it so it was brighter. The model of the keycap and the frog are in two…
Most of the sculpture was AI-made (low-power models), based on historical pictures. The pictures correspond to a non-postprocessed 15 cm print with supports and a layer height of 1.2 mm. Feel free to use it in any way.
Cherry MX-compatible anarchist keycap. The model is optimized for keyboards with LEDs on the inside back of the keys. This model is prepared for a 0.12 mm layer height, so it becomes translucent without the need for transparent filaments,…
Eclipse-tested pinhole projector adapters for an 8 cm diameter tube (poster-type tube). The part where the light is projected is prepared for extending the tube to accurately focus the projection. The pinhole part has 3 sets of holes,…
These are all currently available results.
