Counting matching models…
This is a tool for cutting perfect 45° bevels in 6mm Depron/foamboard. It uses a regular shaving razor, which you insert in the slot. Place the tool on the edge of the Depron, slide along and you'll get a single perfect slice of Depron…
A beefy control horn (mainly for flying wings) that needs no Loctite to keep the linkage stopper in place. I needed a horn that would stop the little nuts from eventually flying off, and even though I use Loctite, sometimes the nut would…
The Timeframe uses a LilyGo T5 4.7" e-ink display to show you your daily calendar, agenda, todo list, photos, and anything else you want to show. Instructions on how to make it, along with code, are here:…
This is a tool for cutting perfect 45° bevels in 6mm Depron/foamboard. It uses a regular shaving razor, which you insert in the slot. Place the tool on the edge of the Depron, slide along and you'll get a single perfect slice of Depron…
I have the cheap and very handy DP30V5A power supply, and needed a case for it. I saw some of the other cases here but I wanted a barrel jack for the input and USB and XT60 for the output, so I can connect various other types of…
I needed a harness for my Mavic Air so I can deploy various payloads to it, so I designed one. It's fully printable, all-plastic and has a thick flat base so you can glue payloads to it. It fits exactly on my printer, I have also glued a…
A better firewall for the FT Goblin, with holes for the hot glue to "catch" better. Every other mount I used has come unglued because there's nothing for the glue to adhere to. This is designed for 16x16 motors, the OnShape model is…
A sturdier, larger motor mount for the C1 Chaser, with holes for 16x16 and 16x19 motors. Print in clear PETG with the mount side on the bottom, with supports on print bed for the outside fins. OnShape link for remixing:…
I got a Blue Yeti X and I needed a pop filter for it, so I made one. It consists of two rings, between which you sandwich a piece of thin fabric, stocking, or mesh. I then used CA glue on the back side of the rings to glue them together,…
I needed a DJI AU/camera holder for my Drak, and I couldn't find one that was very light, let airflow through, held the AU securely but still took minimal effort to remove (so I can hotswap), so I made one. There's a latch that mounts on…
I remixed sporadic's dial gauge holder for two reasons: One, it wouldn't fit my v2.1, and two, I bought this dial gauge thing on eBay and it wouldn't reach far enough down to touch the plate. If you have a v2.1 and that gauge thing, this…
This is a hex key holder for the Wanhao Duplicator i3 v2.1. I needed a place to hold my hex keys, and I noticed a couple of small holes on the side of the gantry (probably for putting a z-switch on), so I designed this little part to go…
These are all currently available results.
