Counting matching models…
Version 2 - moar magnets: After feedback about the camera not sticking - probably due to weaker 6mm x 20mm x 2mm magnets than the ones I had available, the model was revised with the following changes: The 6mm x 20mm magnet is…
This is geared manual winder for 8mm or 16mm cine film. It is designed to attach to the end of a 2020 aluminium extrusion, or can be screwed down to a piece of wood using the 3d printed stand. It can be used for rewinding film after…
I had a need for a portable power source for another project - as I had a couple of the (green) Bosch tools made this adapter so I could repurpose the batteries and chargers. The print is in two parts. I printed mine in PLA which seems to…
September 2025 - V2.2 - added a boolean flag to the VarSet in the FreeCAD model to allow for winder spindles that have a square section throughout. V2.1 - made the core thickness parametric to cater for 35mm and 8mm film cores. Uploaded…
I wanted to reuse a Mean Well LRS-350-24 24V power supply on the bench for another project, so made this simple cover to hide the connectors and protect from the exposed mains voltage. Printed in PETG (for strength and temperature…
This is a simple compact magnetic stirrer made to help mixing up photographic chemistry, though it could be used for other chemical mixing purposes. The idea is based on a number of DIY projects seen on YouTube that use an old computer…
A simple stand to hold the new Cinestill CS-Lite under the Valoi360 Advancer. Recesses on the bottom to take 10mm diameter rubber feet. There's a cutout in the side for the cable and switch. The rubber feet of the film advancer engage in…
I wanted to break out a 9 pin RS232 serial port from the header my PC's motherboard to the front panel, and at the same time retain two USB 3 ports. This adapter fits in a standard 3.5" floppy drive bay. The USB3 cable is a StarTech.com…
The late 1960s/early 1970's Fujica P300 Single-8 cine film camera has a fully automatic exposure system that relies on a light dependent resistor (LDR). It has no manual override, which was a problem for the one I have that had a failed…
This is a simple push-on protective lens cap and push-on lens hood for the Fujica P300 Single-8 cine camera from the early 1970s. Printed in ABS at 0.2mm layer height on a Prusa MK4, though PLA or PETG should work fine. I painted the…
These are all currently available results.
