Counting matching models…
For bowden fittings that allow the tube to pass through it also allows for easier loading of the filament than. through the hole. Printed in PETG with 0.4mm nozzle and 0.2mm layerheight. No supports, drilling, or threading needed for the…
Remix of Toms design that fits a tube in both ends and does not need drilling out. My print gave a easy friction fit. Added a version V6 with a PTFE/bowden tube coupler. Printed on 0.6mm nozzle with 0.3mm layers. I also added my modified…
I needed somewhere to put my laptop at my desk, and storing it vertically by the desktop seemed like a nice place. So I made a holder that slides under my desktop and keeps my laptop vertical without falling over. My specific laptop is a…
Filament drybox from IKEA Samla 22l box, 8mm rods, and 608 bearings. Fits up to 5 rolls. Does not need any fasteners, but a M3 screw from the bottom in each end makes it more stable and easier to adjust. Part list: 2 single version 4…
A quick and simple design printed standing on Monoprice i3 Mini. The .step file has holder for the jack housing keeping it nice in place, and preventing the mic from rotating away from your mouth. Category: Audio
For outside diameters the distance of peaks are 50mm, and for inside measurements it's 52mm. Some calculations are required. Actually measuring the print will help achieve higher accuracy. The peaks of my print was about 0.4mm off. For…
My bath/shower mixer tap's diverter failed to do much. No water pressure in the shower. So this part solved it. SHOULD BE MOUNTED THE OTHER WAY AROUND FOR BEST SEALING. Onshape link:…
These are all currently available results.
