P
PrintablesCalvin&hobbes3D
Degraded Master Sword
Just a repost of https://www.thingiverse.com/thing:5988140 Because I couldn't find one on printables.
- Downloads
- 481
- Likes
- 72
- Rating
- 5
All models
Counting matching models…
P
PrintablesCalvin&hobbes3D
56mm 3x3 Speedcube
I haven't printed this yet, but it needs 12 edges, 8 corners, 6 centers, 6 center caps, and 1 core. you also need 6 springs, and six 2.5mm screws. other sizes may work. 4x1 magnets.
- Downloads
- 136
- Likes
- 15
- Rating
- 0
P
PrintablesCalvin&hobbes3D
Snap circuits junior motor insert
I had an old snap circuits junior set, and the insert that goes on the motor broke. I quickly sprang into action, and modeled a insert. it took me three iterations, but it only took 1 minute to print, (quite literally) so within 5 minutes…
- Downloads
- 125
- Likes
- 12
- Rating
- 4
P
PrintablesCalvin&hobbes3D
Master Sword Wall mount for Velcro command strips.
print with supports, and the bottom part going up
- Downloads
- 59
- Likes
- 10
- Rating
- 0
P
PrintablesCalvin&hobbes3D
Fear of fingers
A key cap to make anyone scream in Pain!
- Downloads
- 37
- Likes
- 18
- Rating
- 0
P
PrintablesCalvin&hobbes3D
TinyTest
This is the TinyTest, Made to test the limits of your printer, while saving filament. Settings Raft: No. Supports: No. Brim: No. Infill: 2.5% or more. Layer thickness: Doesn't matter. Angles for overhang are: 45°, 52°, and 60° Note: tiny…
- Downloads
- 12
- Likes
- 1
- Rating
- 0
These are all currently available results.