Counting matching models…
Model Description Flat, 3-way junction box for Wago 221 series wire clamps. This model is heavily inspired by a design shared by https://www.printables.com/@geroulas . This version features a more rigid hold on the Wago clamps by using a…
Resonance probe for input shaper calibration for the Klipper firmware based on a RP2040 Zero and a generic ADXL 345 Sensor SPI breakout board.. Wiring: RP2040 ADXL 345 GPIO 0 SDO GPIO 1 CS GPIO 2 SCL GPIO 3 SDA GND GND 3.3V VCC…
Mounting plate for the common XY-3606 5V Voltage Regulator which is otherwise missing mounting holes. Print Settings Printer: Crealty Ender 3 Rafts: No Supports: No Resolution: 0.2mm Infill: 40% Filament: Extrudr PLA blue Category:…
Stand for the Fire HD 10 Gen9 2019 Model. The model is more or less generic and parametric so you should be able to adapt this to your needs as in different angles or other tablet types.…
Low profile macropad with mechanical keys. Parts Amount Part Notes Sources 13 1N 4148 Diode DO-35 Diode Formfactor works best Jellybean item: Amazon, Ebay etc 12 Cherry MX Low Profile Switch Cherry MX Low Profile Switch | Lower body part…
Case for the WEL3005 electronic load module with 4mm banana plug sockets and XT60 connector mount. The load module itself can be powered from an USB-C PD Breakout module such as https://de.aliexpress.com/item/1005004386869398.html
Small enclosure for the MH-Z19 Sensor module and a ESP8266 D1 Mini. If your sensor module came with headers pre soldered you will either have to clip the back side of the headers flush with the pcb or desolder them - otherwise it won't…
Travel enclosure, bottom case and a tilt stand for the Sofle Choc Keyboard. Print one copy of the files mirrored. Tilt stand is configured to 15º, use the OnShape link below to customize. There is no special attachment of the Tilt-Stand…
Two-Part Case for the UMA-8 Microphone Array by MiniDSP. 4x M3x8 screws are required for assembly. The rubber feet model fits socket head bolts. Use PLA for the enclosure, TPU for the rubber feet. Print Settings Rafts: No Supports: No…
Mounts for the Omron Subminiature Basic Switch Series (Omron SS). Switches attach to the mounting plate by a snap in mechanism. Endstops are meant to be mounted at the back of the Sidewinder X1. Indended to be a replacement for the stock…
Not much else to add. Sharing the parametric OnShape project as well, you should be able to configure the variables for any similar battery type
Axoloti Core Case A two-part axoloti core case ( http://www.axoloti.com/product/axoloti-core/ ) Non Printable Parts 12* M3x6 Screws Notes Not much to say, what you see is what you get. I did not design any holes for the LEDs. They are…
Spool Holder for 20X0 Extrusions Meant to be mounted on top of the printer by attaching to the horizontal 2020 extrusion profile. Personally, I currently use this on a Sidewinder X1. I see no reason why it would not fit on a Ender-3,…
These are all currently available results.
