Counting matching models…
Print in the shown orientation with supports. Recommended to print in PETG or stronger, PLA is too brittle and may break. Sand the bottom edges if there are rough spots from the supports to make them more comfortable. They're a relatively…
Prints best with supports, PETG or TPU hold up better than PLA/PLA+.
UPDATE: 5 Feb 2023 - added optional TPU gaskets and better photos. I wanted to feed my printer straight from my dry box, but couldn't find a PTFE tube connector design I liked that had an airtight cap, so I made this. The cap seems to be…
A few more models of various open pit mines.
Another topographic model of a mine. This one is pretty spread out, so I had to zoom out quite a bit to capture everything. Scaled to be ~145mm diameter, photo was printed with 0.16mm layer height and 15% adaptive cubic infill.
I have a 1980's era Hotpoint fridge in the garage that's used for drinks. Over time the plastic caps covering the handles became brittle, broke, and fell off, exposing sharp metal pieces of the handle. I used the remaining broken pieces I…
These are all currently available results.
