Counting matching models…
Small and robust travel case for Oral-B electrical toothbrushes. It's a one-print-design with joints that rotate freely, yet without wobbling and the small clip makes sure that the case doesn't open accidentally. To be on the safe side…
Used to detach the filament sensor from the original spool holder. You might want to do this when building a custom enclosure for your printer or when using a different spool holder. Features: Easy print without support structures Firm…
This self-designed flexible case fits perfectly on the Apple iPhone 13 pro (iPhone 14 pro version included as well). It offers precise cutouts and covered buttons that are easy to press. I had to experiment with the print settings quite a…
Material list (non-printed parts): 2 IKEA Lack table 55x55 cm (or stack 3 if you prefer a higher standing position) 2 Plexiglass (Width: 445mm Heigth: 527mm Thickness: 3mm) 2 Plexiglass (Width: 222mm Heigth: 527mm Thickness: 3mm) 1 PVC…
A reinforcement bracket designed to stabilize all sorts of IKEA LACK enclosures. Use 4x20 mm wood screws for mounting. The upper leg screw holes need to be pre-drilled with the whole screw length, but you can also leave those empty as I…
Aluminium profile cover 40x40 (N8I) with good fit. Useful to cover the sharp edges and keep off dust.
This model was created from a drawing I made in GIMP. To print it with two colors you have to insert a pause for filament change at the layer before the outlines will be created inside your slicer software. The base layer is just 0.7 mm…
This model was created from a drawing I made in GIMP. To print it with two colors you have to insert a pause for filament change at the layer before the outlines will be created inside your slicer software. The base layer is just 0.7 mm…
Installation: Print the two parts. Mount the base plate to the ceiling with double-sided tape (even normal tape could work if you make use of the 3 outer holes). Attach the cover by rotating it onto the base plate.
This model was created from a drawing I made in GIMP. To print it with two colors you have to insert a pause for filament change at the layer before the outlines will be created inside your slicer software. The base layer is just 0.7 mm…
Assembly instructions Print all parts. (Note: No support needed, but your printer should be able to handle 60 degrees of overhang) Prepare a thin foil e.g. Overhead film as shown in the picture below* * If you print the window version,…
This model was created from a drawing I made in GIMP. To print it with two colors you have to insert a pause for filament change at the layer before the outlines will be created inside your slicer software. The base layer is just 0.7 mm…
This is my version of a simple, effective and easy-to-use clothespin. It can be used on a standard laundry rack e.g. IKEA with a diameter of around 3mm. Conventional clothespins often leave marks on clothing, but this one is gentle and…
Printing instructions : I used PLA for printing. No support structure needed. Just align the tip of the cap with your printer bed. Working Instructions: The bottle cap becomes watertight when you screw it on with a little force. I…
These are all currently available results.
