Counting matching models…
To assemble and print this lure: Print at 100% infill. Screw in eyelet screw size 4x8mm gently ( A dot of glue will work well.) Use 22 gauge wire for joints and bend ends at bottom and top. If you have any suggestions as to what I should…
To print and assemble this lure: Print at 95% infill Supports neccesary Use a 5mm Raft Screw in 4x8mm Eyelet screws There are 3 holes, but I only used 2 because I had a treble hook Attach 3mm eyes with a dot of glue A like and a comment…
To print this lure: Print at 95% infill SUPPORTS NECCESARY Use a 5mm raft Screw in 4x8mm eyelet screws Attach 5mm eyes with a dot of glue A like would be highly appreciated;) Happy fishing!
To print and assemble this lure: Print at 75% to 85%. Insert one 4.5mm BB into Body and Head during print. To assemble, insert 4x8mm eyelet screws into holes. Then put 22 gauge wire through the screw eyes in the middle of the bait and…
To print this figure Print at 10% infill Supports only on the earmuffs To assemble: Glue in eyes, nose, earmuffs & hat with a drop of glue.
These are all currently available results.
