3 models
I doubled the height of the top adapter that launches the propeller. This allows you to load and launch two at the same time. I printed in PETG but PLA would probably work too. .16 layer height since it didn't affect print time much. 4…
The aux cord in the Yaris sticks straight up in the center console leaving it open to damage when things are set on top. This fits in seemlessly using the blank slot next to it and covers the port from damage. I print in two pieces where…
This allows you to use a smaller hole in your door than the one required by Teeho. This adapter plate slips between the outside keypad and the door. It will fit snug with no adjustments needed. You will also need to print the adapter…
These are all currently available results.
