P
PrintablesSevro1983
1/10 Scale RC Drift Wheel V2
Should print with only a circle in the center if you print it face up I set my deg @ 62 to prevent any small slivers for some of the edges and it prints great.
- Downloads
- 82
- Likes
- 16
- Rating
- 0
All models
Counting matching models…
P
PrintablesSevro1983
MST RMX 2.5 Rear Magnet Mount Enhancement
I modified the bracket that came with the kit from amazon ($10) part. https://a.co/d/hPaOuqX The original bracket didn't leave a lot of room to get your fingers into so I created this in order to spread it out. This also had a great side…
- Downloads
- 71
- Likes
- 15
- Rating
- 5
P
PrintablesSevro1983
MST RMX Motor Fan mount
Made this to mount a cheap 30mm fan on my rc car. Provides a ton of cooling for the 1/10 scale motor especially if you're drifting with boost and turbo, you pretty much need one. Not sure if it works on any other cars but it works on my…
- Downloads
- 71
- Likes
- 6
- Rating
- 0
P
PrintablesSevro1983
MST RMX Upper Battery Mount (Howler Symbol)
This is a upper battery mount for the MST RMX rc drift car. I used all the original hardware and this works great if your going for that extra body movement from having the battery up high. You don't need to buy any additional hardware…
- Downloads
- 57
- Likes
- 3
- Rating
- 0
P
PrintablesSevro1983
1/10 Scale Drift Wheel
Should print with only a circle in the center if you print it face up I set my deg @ 62 to prevent any small slivers for some of the edges and it prints great.
- Downloads
- 39
- Likes
- 11
- Rating
- 0
P
PrintablesSevro1983
MST RTR Controller Steering Wheel
Pretty simple to swap out. Just the one screw gets removed then pull the original off. The rubber can be reused on this upgrade.
- Downloads
- 21
- Likes
- 4
- Rating
- 0
P
PrintablesSevro1983
MST RTR Stock Trim Buttons
I made these to spruce up my stock MST controller that came with my MST RMX RTR 2.5. They are really simple to print and I made them in two parts so that you can print without support. For this controller you just need to print two sets…
- Downloads
- 11
- Likes
- 1
- Rating
- 0
These are all currently available results.