Counting matching models…
I printed it with the back side (with the triangle pattern) away from the build plate which required more support but resulted in a much nicer finish for the exterior of the phone case. the case with the hole punch out is what I used the…
A case for the LTT Screwdriver which also holds 24 bits. Any 1/4" Hex bits will fit, not just shortie bits or full size, both will work. I printed it all in PETG using a .28mm layer height. I haven't tested the up-to-date version of the…
Similar to my previous design however without the latch and instead shutting with the help of 10 magnets. In the most up-to-date versions of both the old nonmagnetic as well as this new magnetic version, the bits are held in place by bit…
These are all currently available results.
