Counting matching models…
The original lid is broken, but the shaker is still fine? Print yourself a new lid. I recommend using TPU, I printed this lid with Bambu TPU for AMS with a shore hardness of 68D and it works fine: noozle 0.6mm 0,18 mm layer 3 wall loops…
This is my mount for 1" motorbike handlebars for the insta360 GPS Smart Remote . To prevent the bracket from twisting on the handlebars, I recommend a maximum 1mm thick rubber pad between the handlebars and the bracket. For mounting you…
{{hello world}} This is my MagSafe compatible charger mount for the MG4 dashboard which is designed to fit the original Apple MagSafe charger with the 95 cm cable. It’s important to print this mount with heat resistant filament - e. g.…
Print it, glue it, clip it to the back of your Switch Lite Et voilà: A nice storage for two Nintendo Game Cards attached to your Switch Lite. Have fun _(ツ)_/ Category: Video Games
This is my coin capsule for EURO coins 10, 20 and 50 Cents as well as 1 and 2 Euro. I left the 1, 2 and 5 cents away cause .... . The trays will need some sanding to fit, and you will also need some springs (7x12mm, 5 pcs). To properly…
This is my case for adding an Apple AirTag to my Dango Wallet. It is designed so that the AirTag sits as flat as possible on the wallet. Should fit to any wallet which has an free and open credit card pocket on the outside. Print Settings…
This is a set of four riser for the german "Frankfurt Brett" available at https://www.frankfurter-brett.de/en So it's now 5cm higher, which makes snipping a bit more ergonomic on the one hand, and on the other hand the GN containers don't…
These are all currently available results.
