Counting matching models…
Simple filament sensor for the HGX-Lite. Requires the following parts: Switch: D2F-01F3L-D3 2 - M2x10 self tapping screws 1 - ECAS fitting with bottom plastic/rubber removed 1 - M3x6 Screw I recommend these switches as they have fairly…
I'm converting my SV08 into a tool changer so needed more power to run the toolheads. Print in ABS or PETG. 4 walls with 15%+ infill. Required hardware: 3 - self tapping screws (saved from removal of original power supply) 2 - M3x6mm BHSC…
I wanted an easy to print dock that printed as a single piece (ok it's actually 2 pieces) with no supports and built in nozzle blocker. You will need: 2 - 6x3 Magnets - Highly recommend countersunk magnets 2 - M3x10(ish) FHCS for leveling…
Organizers to fit in the Lego Medium Box that the Lego Education Spike Prime comes in. There are 2 corners (A and B) you'll need 2 of each corner and a middle for a full set. Everything should fit on a 256x256 sized bed (thought the…
Print in the filament of your choosing (though maybe not flexibles…) To adjust the tightness of the fit you can loosen the actual feet on the sBitx and spread them or move them together to get a the 3D printed feet to be a nice snug (but…
Super beefy tool dock for the SV08. Do you need a dock bar that doesn't move and you can lift the entire printer with? Well this is the one! Requires 3 pieces of 2020. Also supports a brush…or not if you don't want one. WARNING - You will…
I printed in PLA with 4 exteriors. For the roll holder you'll need a piece of bowden tube which acts as a bearing. Cut the bowden to length and then push it in place.
A calibration probe that uses the same dowels and bushing as a StealthChanger tool changer build.
Print standing up with the magnet side down. Requires 10x5x3 magnets. There are likely way more magnet slots than need to be filled. Minimally I'd recommend 3 on the top and 1-2 on each side. Magnets should press fit but a drop of super…
Feet for the zBitx. Put them on the middle and slide them to the outsides to capture the bolts that hold the feed in place. Recommend PETG or ABS/ASA for these.
Printed in PLA with tree supports (though PETG/ASA/ABS/etc should be fine). Holes are for 8x3mm Magnets to attach to the back of the printer when not in use. Used a piece of bowden tube just attached to the back filament guide and hanging…
Print how the StealthChanger documentation tells you to print. Fan and hotend wires run up the newly added corridors. LEDs and toolhead fan exit in the other channels.
This will likely void your warranty. I take no responsibility for this messing up your equipment or causing issues. Do this at your own risk. I'm not a huge fan of Power Pole connectors. They're nice but I find them rather large for what…
Print in ABS, ASA, PETG or whatever material you want to handle the temperatures that you need it to handle. Insert the 2x4mm magnets which should all be a press fit. The magnets provide a somewhat loose hold onto the zBitx. It is…
Simple holder for some Dynamite Hex Drivers. Print it in whatever material you choose. Add in the adapters, push it onto your wall. Profit.
These are all currently available results.
