Counting matching models…
Edit 2/14/24: Updated wiring/config for proper signal to the fan. Cpap will no longer kick on from power-on until OS is booted. #CPAP [fan] pin: PE5 kick_start_time: 0.2 off_below: 0.2 cycle_time: 0.005 shutdown_speed: 0 max_power: 1…
After trying another design and breaking the ‘toes’ off of a few feet previously (probably a print issue, admittedly) I decided to utilize Tterbocharged's file for the v400. Now the ball is fully supported around its circumference and…
UPDATE 4/5/24: Added another model for use with factory square-style flsun hot ends as the original model was made with the triangle labs hot end. UPDATE 1/26/24: I believe this will also be fully compatible with Cartography sensors as…
Cpap duct for use on v400 with Orbiter v2.0 extruder
I'm currently using this light: https://www.amazon.com/dp/B0BCVHMJ46?psc=1&ref=ppx_yo2ov_dt_b_product_details You may or may not need supports depending on your printer settings
Beta Mounting requires material to be removed from the rear of the Flsun heater/fan mount to clear the front of the orbiter. A cut ‘template’ is provided. BOM: 3x m3 threaded inserts 5x m3x~8mm screws
This base mount allows you to use TeachingTech's ball-joint camera mount system on your Flsun v400 (and possibly SR) rail. Specifically made to be short enough to work with enclosures. Currently designed to use phnxdrgn536's hardware…
After ruining a few factory probes I decided to look into upgrades. I haven't purchased one yet but in case anyone else would like to try here you go.
The rear speaker area of the 2-door Rav4's seems to be smaller than the 4-doors. The sides have been truncated/chamfered to clear the bracing for the window and door, which required the screw holes to be moved. 128mm speaker cutout.…
Larger duct for qidi carbon filter
I wanted to add additional lighting that wasn't at the top of the enclosure or moving with the effector . This is intended for use with my wiring-friendly covers found here , as well as top cover spacers such as these (although any of the…
If you keep your enclosure top level with your printer enclosure, this adapter will keep the filter body tucked up slightly higher than the original.
Yes.. Another set of top caps for the v400. I decided to add lighting to the rail extrusions and needed a way to pass wires over without pinching them. In addition to a gap in the center for access to the main board there is also room for…
Info: This was designed for either passive, active, or dual cooling specifically using the Armor Case passive cooling case and Argon HAT (although neither are required). Included are: bases with and without feet, optional feet, tops with…
In an attempt to quiet the blower fan that I've added to my FLSUN v400 stepper motor drivers I decided to try the board linked below. Add some double sided tape to attach it in place and you should be good to go. Feel free to comment if…
I haven't found a better mounting system for my needs, I just needed a slight change to suit my needs. You'll need one m5x10 socket cap screw (or similar depending on your camera)
These are all currently available results.
