Counting matching models…
CTRL Keycap for Corsair STRAFE mechanical keyboard . My wife's CTRL key busted after playing too hard, so I made this using the Parametric Mechanical Keycap Library . There are two versions. The rounded version has a round mount similar…
Small display stand for bracelets, bangles and other similar jewellery. Has a small storage space at the bottom to hold other small items e.g. rings, earrings etc.
This is a Gridfinity compatible storage box for the Tni-U 45 piece precision screwdriver set . Might work for other similar sets, but the slots for the driver and extensions are fairly form fitting so your mileage may vary. I made it 5x2…
I got sick of my cutting boards falling over in the kitchen when I bumped anything in their vicinity, so I threw this basic stand together to keep them together and upright. I have a lot of boards so this holds up to 8, each gap is 8mm so…
This is a remix combining two other remixes of a planetary-geared filament guide. I have a sealed box holding up to five commonly used filament spools at a time which feed out from the side and up to the printer which sits on top of the…
This is a Gridfinity compatible storage box for the Hammerhead Li-ion screwdriver . Also has a small lowered area for holding screws or other bits. 2023-04-26: Added a variant with a deeper recess compartment for more storage if bits and…
This is a simple adapter I made to connect the hose connector for my ResMed AirFit P30i CPAP mask to one of those cheap ozone cleaners you find on eBay (e.g. https://www.ebay.com.au/itm/154431321036 ). This should theoretically fit any of…
Modern design for a toothbrush holder meant to hold one toothbrush. Supports needed for the top ring (I used snug supports in Prusaslicer to keep them on the rim of the bottom half to reduce filament usage and scarring).
Spool holder for standard 1KG filament rolls. I used these as part of a project to build my own sealed filament storage. When printing, I tacked a couple of support enforcers around the top lip of the holder piece in the middle just to…
After upgrading my printer with KevinAkaSam's fantastic belt driven Ender 3 mod , I found I couldn't continue to use the planetary gear filament guide I had been using up until now as it no longer fits where it did. Rather than…
These are all currently available results.
