Counting matching models…
I recently purchased Azul and was sad to find that all the Azul overlays found on Printables did not fit this newer board. The squares were off by a few millimeters. I remixed the original overlay specifically to fit my board and only for…
My 8 year old son needed to make a cabin out of popscicle sticks and the Mini Craft Miter Box was perfect for me to use but was a little too small for him. Created this base to make it easier for him to cut the sticks by himself. You can…
Flatten the bottom of the grip so that it could adhere to build plate more easily with just a brim and can print more reliably.
I love the design of the original model but when it's being used as an extended grip, the console can easily move and fall off. I added tabs that holds the console in place when using this as a grip.
Simple stand for the grip. Could also be used without the grip for playing with a controller. The viewing angle is perfect (IMHO) for when sitting at a desk/table. I don't charge it while it is on the stand but there is a hole to pass the…
Replacement cushion for the frame plates. You can print it in TPU and use double-sided tape. Or you can just use it as a template to cut out some rubber sheets or from left over tennis over grip, and then attach it via double-sided tape.…
I lost my starting pin so I made this simple replacement one that uses any left over tennis string. I have for each string I own so that the thickness is the same for the string I am using. It makes setting up my clamp tightness more…
These are all currently available results.
