Counting matching models…
This piece is an interface between a GoPro base mount and a bicycle light with a slide mount. Back piece was used to help hold it to the surface while printing, and was removed once complete.
A simple card holder design to display your collector cards for viewing or photography. Please give me feedback if you think the dimensions are good, or could be improved.
Rather than using a piece of paper every day, I thought a coin would help in this situation. Plus it was an opportunity for me to experiment with switching filaments. It came out good, although I had to reattach part of the edging with…
Made this for an elderly person to assist with tightening and loosening their gas cap. Should fit up to 2 3/4 " gas cap
Created a simple slip-on chain guard for a Colt BMX bike. Inside diameter is 19 mm, length is 190.5 mm, thickness is 4 mm.
This is a simple plant lattice that goes in your house plant pot to help the vines attach to something. It is 5 in x 6 in lattice with approximately 1.5" in legs (12.7 cm x 15.2 cm, legs 3.8 cm)
I designed this hook to latch onto the slot on an airplane seatback. The other end I am incorporating a string and printed rod (separate make) to fit loop that is part of my ipad cover.
The frame of my headphones was coming apart and poking me in the side of my head. I created the clip to replace the rubber band I've been using.
This is a floor mat clip for a 2008 Toyota Tacoma. The print (in photo) failed on the base plate, but enough was made to call it good. I used ASA as PLA would not hold up.
These are all currently available results.
