P
PrintablesMattHecht
Hot Wheels Track Connector
Basic track connector for hot wheels track
- Downloads
- 1,061
- Likes
- 98
- Rating
- 5
All models
Counting matching models…
P
PrintablesMattHecht
UMPIRE COUNTER
This is my attempt at an umpire too. Used to keep track of balls, strikes, outs, and innings. Each wheel is held in place with an 8-32 bolt and nut and this holds the top and bottom together too. You may need to place a washer under the…
- Downloads
- 298
- Likes
- 26
- Rating
- 5
P
PrintablesMattHecht
Speed Square
This is a speed square I designed. It has measurement increments of ¼" with numbers every inch. It also has angle measurements every 15 degreed and labeled on one side. Edit: Model can be printed vertically for better clarity on numbers…
- Downloads
- 211
- Likes
- 22
- Rating
- 4.33
P
PrintablesMattHecht
1/10 Scale Car Ramp
This is a 1/10 scale automotive ramp to put in a garage. It has a 8" height and a 17 degree incline for lower cars. Has slots cut so water or debris can drain off the tires.
- Downloads
- 193
- Likes
- 37
- Rating
- 4
P
PrintablesMattHecht
Standard/ Metric Allen Holders (T-Handle)
There are two models. One is a holder for your standard size allen wrench T-handles and the other is for your metric size allen T-handles. These are meant to sit on your work bench or in a deep drawer in your tool box. I printed these…
- Downloads
- 97
- Likes
- 4
- Rating
- 0
P
PrintablesMattHecht
Money Sign Piggy Bank
Money sign piggy bank. There are three separate pieces. The dollar sign (top) can either be set or glued into the slot on the top of the box. and the bottom plate has 4 holes to use small screws. find the best ones that thread into the…
- Downloads
- 65
- Likes
- 6
- Rating
- 0
P
PrintablesMattHecht
DISHY MOUNT FOR SATELLITE DISH POLE
This mount was created to mount the StarLink dish to an existing satellite dish pole. The mount uses a 2" hose clamp to holed the mount to the satellite pole. Feed the StarLink cable through satellite pole and through the mount, then plug…
- Downloads
- 54
- Likes
- 2
- Rating
- 0
P
PrintablesMattHecht
80-20 Mount for 221-2401 Wago connectors
This is a simple block that you can mount to 80-20 that hides your 221-2401 Wago connectors. The connectors are held in with a small set screw. This holds 4 connectors but could be made to hold more if needed. Once you have attached your…
- Downloads
- 4
- Likes
- 2
- Rating
- 0
These are all currently available results.